Step 1: Assemble the projector screen and bracket, see assembly/operation manual and place the assembled projector screen on the TV cabinet after.
Step 2: Adjust the height of the screen. The base of the screen is 30-32 cm from the surface of the projector to ensure the level of the screen.
Step 3: Install the projector, make sure that the centerline of the projector is aligned with the centerline of the screen.
Step 4: Turn on the projector and adjust the distance from the projector to the screen until the left and right sides of the projection are in the screen, and the projection is perpendicular to the screen (the distance between the two corners of the projector and the wall should be equal).
Step 5: Adjust the “tilt adjuster” on the bottom of the projector to adjust the picture (see the screen angle adjustment instructions for details).
If the left or right of the projection screen appears small just like the left and right illustration above, please rotate the projector slightly to the right or slightly to the left until the “normal” projection screen appears.
If the image is not clear enough, please use focus +/- buttons on the remote control to adjust it.
If the projected image is tilted as above illustrations, adjust the tilt adjuster of the projector to correct it.
When the “tilt adjuster” is adjusted to the limit but the projection image is still titled as shown above, please further adjust the left/right height adjusters simultaneously in the same degree until the “Normal” image is displayed.
If the projected image is slanted as above illustrations, raise or lower the right height adjuster.
When the “right height adjuster” is raised to the limit but the projected image is still slanted to right, please lower the “left height adjuster” until the “Normal” image is displayed.
When the “right height adjuster” is lowered to the limit but the projected image is still slanted to the left, please raise the “left height adjuster” until the Normal image is displayed.